Easy to install, screws onto tyre valve stem.

With the Aussie flag on show, these valve caps will add a bit of cool novelty to your ride.

Made of high quality alloy (less likely to crack or come off than plastic caps), durable for use.  Includes rubber ring inside valve cap to prevent air leakage.

These metal caps fit most tyre valves, suitable for car, truck, motorcycle and bicycle.

Note: In some cases, there may be a reaction between the aluminium alloy and the metal of the valve stem (depending on the metal used) causing the valve cap to get stuck.  It is suggested  to use teflon, vaseline oil or a small squirt of WD40 on the threads or in the cap to help prevent corrosion.

The post Australian Flag Tyre Valve Caps appeared first on tommytwice.com.

This decal is made from durable, fade-resistant vinyl and has good waterproof performance.

Size: 40 x 8 cm
Colour: Black

Application instructions:

Note:  Application is best if applied in temperatures between 15 and 25 degrees Celsius.

1. Prepare the surface
   All adhesive applications must be applied to a clean surface, free of all wax, oil and grease, including under the edges.  Give it a thorough wash, then meticulously clean it with wax and grease remover, followed by isopropyl alcohol (rubbing alcohol) on a microfibre towel.
2. Remove backing paper
   Remove backing paper from decal, exposing adhesive.
3. Position decal
   Position decal, being careful not to stretch the vinyl.  Lay on to the application surface, then go over the entire surface gently with an application squeegee to ensure bond.  Carefully work out any air bubbles by squeezing across the vinyl edges.
4. Remove protective layer
   Carefully remove the protective premask by pulling parallel with the decal immediately after application.

Note:  To assure a permanent bond please allow at least 72 hours in direct sunlight before washing or waxing.

The post La vita è bella (Life is beautiful) Car Vinyl Decal appeared first on tommytwice.com.

This decal is made from durable, fade-resistant vinyl and has good waterproof performance.

Size: 90 x 21 cm
Colour: Available in Black or White

Application instructions:

Note:  Application is best if applied in temperatures between 15 and 25 degrees Celsius.

1. Prepare the surface
   All adhesive applications must be applied to a clean surface, free of all wax, oil and grease, including under the edges.  Give it a thorough wash, then meticulously clean it with wax and grease remover, followed by isopropyl alcohol (rubbing alcohol) on a microfibre towel.
2. Remove backing paper
   Remove backing paper from decal, exposing adhesive.
3. Position decal
   Position decal, being careful not to stretch the vinyl.  Lay on to the application surface, then go over the entire surface gently with an application squeegee to ensure bond.  Carefully work out any air bubbles by squeezing across the vinyl edges.
4. Remove protective layer
   Carefully remove the protective premask by pulling parallel with the decal immediately after application.

Note:  To assure a permanent bond please allow at least 72 hours in direct sunlight before washing or waxing.

The post Universal Car Bonnet Vinyl Decal – Black or White appeared first on tommytwice.com.