Make your car stand out from the crowd with this do-it-yourself vinyl decal in a unique stripe design for your car bonnet.
This decal is made from durable, fade-resistant vinyl and has good waterproof performance.
Size: 90 x 21 cm
Colour: Available in Black or White
Note: Application is best if applied in temperatures between 15 and 25 degrees Celsius.
- Prepare the surface
All adhesive applications must be applied to a clean surface, free of all wax, oil and grease, including under the edges. Give it a thorough wash, then meticulously clean it with wax and grease remover, followed by isopropyl alcohol (rubbing alcohol) on a microfibre towel.
- Remove backing paper
Remove backing paper from decal, exposing adhesive.
- Position decal
Position decal, being careful not to stretch the vinyl. Lay on to the application surface, then go over the entire surface gently with an application squeegee to ensure bond. Carefully work out any air bubbles by squeezing across the vinyl edges.
- Remove protective layer
Carefully remove the protective premask by pulling parallel with the decal immediately after application.
Note: To assure a permanent bond please allow at least 72 hours in direct sunlight before washing or waxing.